Starting the machine

	After confirming the power specifications, you can proceed to connect it to AC power and turn on the machine. There is a power switch on the left side of the power supply box, push it up to the "ON" position.
	At this moment, INS-300 will make a "beep" sound and the eight detection lights on top of the detector will illuminate one after another from the first to the eighth. A high-pitch "beep" sound will also correspond to the illumination of each light. At the same time, the conveyor belt will be activated and halted.
	Please observe if the conveyor belt is moving in the direction as shown in Figure 1. If it is the same direction, congratulations! You may continue to read the second paragraph. If it is going in the opposite direction, please push the power switch down to the "OFF" position.
	And look for the reverse switch behind the power switch on the power control box.Then, push it to the opposite direction and turn on the power (i.e., push the power switch to the "ON" position). Observe now! The conveyance direction is the same as that indicated in Figure 1.
	The description above regarding the reverse switch will only occur in a triple-phase 220VAC or 380 VAC power supply specification. If it is a single-phase 110//220 VAC, then you will not have to worry about the problem of reverse direction.